COMPLIANCE INFO_1985-2007 - Laserfiche WebLink

Home Browse Search

Cot 16 07 07:19p Sheila Wallace 9256897921 p.9 2.3.37 The Conduit from the Pneumercalor TMS -2000 panel, in the shelter to the point it enters the ground shall be 1 inch rigid steel conduit A t" rigid seal -off shall be installed on the conduit as the first fitting as the conduit enters the building. All below grade conduit shall be SCH 80-1"!electrical PVC. 2.3.38 Wire conductors from the Pneumercator panel to the Turbine shall be 5 pairs of Belden 8441, 22 gauge stranded, braid shielded w/ drain wire, PVC jacketed. 2.3.39 Wire conductors from the Pneumercator panel to the existing Hoffman Box Alarm Panel in the shelter shall be a six pair, 22 gauge solid, PVC jacketed, Belden 8743. 2.3.40 Wire conductors from the Pnerrruercator panel to the Pneumercator external alar, P/N RA -200 shall be 3 conductor, 22 gauge str=hxL PVC jacketed, Belden 8443. 2.3.41 All wire connections below grade within the turbine junction box shall be made using 3M Sootchlok 314 connectors, 3M epoxy seal -pack or approved equivalent Note: Wiring splices will not be permitted other than to attach to tin monitoring components within the junction box 2,4 Diel Monitoring System Upgrade 2.4.1 The existing EBW AutoStik 950 and all related components shall be removal. Portions of the existing conduit my or may not be able to be reused. 2.4.2 A new TMS 2000 Pneumercator panel shall be furnished by VERIZON and installed by the Contractor. Refer to Section 6.0 for VERIZUN furnished equipment The Exterior Over fill Annunciator shall be mounted on the exterior of the generator shelter bmg the UST at approximately 7'-0" above finished grade. 2.4.3 Termination of wiring and programming of the TMS -2000 Pneumerratar shall be performed by a Certified Pneumercator Installer. The mounting of the unit and all attachments shall be made by this Contractor. Any alteration to the TMS -2000 Pneumercator unit will void the maim 's wamway and the entire unit shall be replaced at the Contractor's expense. 2.4.4 ImtalWon of this tacit includes atl related components, conduit, wiring and fasteners. Contractor shall be responsible for installing all new conduits in the shelter and no flex conduit is permissible. Installation of flex conduit requires VERIZON approval. in writing from supervisor level. 2.4.5 There are 4 alarms that shall report to the Alarm Hoffman Box in the gememor shelter: Hi Fuel @90%, Low Fuel @5001e, Water in the Fuel @2 inches and Environmental. The Environmental Alarm will consist of 2 different sensors: turbine enclosure and tante interstitial. These 4 alarm points are monitored by VERIZON National Surveillance 24 hours a clay, 365 days a year. Some of the existing conduit may be ; Contractor is to make allowance in his bid to replace conduit as requked to complete the project. The Contractor will be required M pull new wiring from the Pneumercator panel to the Hoffman Alarm Panel. The Contractor will tie the alarm wiring down in the Fn for and label the wiring in the Alarm Panel. Termination to the Hoiiiman alarm panel will be by VER1ZON personnel, unless the termination points have been identified. 2.4.6 The exterior Over -fill annunciator shall be tied to the Over -fill contact only.