Laserfiche WebLink
CPT Controller Manual 4REDJACKET <br /> Failure to follow all instructions in proper order can <br /> cause personal injury or death. Read all instructions <br /> before beginning installation. All installation work <br /> must comply the latest issue of the National Electrical <br /> Code(NFPA 70),the Automotive and Marine Service <br /> Code(NFPA 30A),and local code requirements that <br /> apply. <br /> Only trained and qualified personnel may install, <br /> program, and troubleshoot Red Jacket equipment. <br /> Hazards can cause severe personal injury, death, or <br /> substantial property damage if ignored. <br /> Always tag and lock out breakers on all circuits <br /> connected to the CPT before beginning installation or <br /> service procedures. If the electrical circuit breakers <br /> are accidentally turned on while the CPT is being <br /> serviced or installed,there is a potential for lethal <br /> electrical shock. Also,a spark could ignite any <br /> hydrocarbon vapors present,which could result in an <br /> explosion or fire. <br /> Notice,� The CPT Controller can be used only with constant <br /> pressure turbine(CPT) pumps. <br /> Notice/ Specifications and installation instructions may <br /> change if the manufacturer recommends changes. <br /> Installing the CPT Controller <br /> Before beginning the installation procedures, carefully read and understand all <br /> instructions. <br /> Voltage stored in the capacitor bank of the CPT <br /> Controller presents a risk of POTENTIALLY LETHAL <br /> ELECTRICAL SHOCK EVEN AFTER THE POWER IS <br /> DISCONNECTED. After disconnecting the power,wait <br /> about 2-5 minutes,and until the red Capacitor Charge <br /> light on the Inverter board goes out, before servicing <br /> or removing the controller. <br /> Rubber plugs for the bottom of the contractor's box <br /> are not supplied. Install the vapor seal-offs required by <br /> NEC. Use only gasoline-and oil-resistant materials <br /> between the CPT Controller and the contractor's box. <br /> Failure to comply with applicable codes and NEC <br /> requirements could result in an unsafe installation. <br /> Notice/ Before installing the CPT Controller, carefully plan all <br /> conduit runs and wire connections. The transducer <br /> cable can be run in the same conduit as the pump <br /> wires. <br /> ARE260-240 Rev.A ♦ 6/97 3-3 Chapter 3:Installation <br />