Laserfiche WebLink
CPT Controller Manual RE®,A <br /> CKETY <br /> COVER <br /> CONTRACTOR'S <br /> BOX <br /> �J <br /> FIGURE 3.7 CONTRACTOR'S BOX,SHOWN WITH COVER OFF <br /> Step 7: Reinstall the cover of the contractor's box using litharge <br /> grease. Tighten until watertight. <br /> Notice/ The CPT Controller can be used only with constant <br /> pressure turbine pumps. <br /> The transducer cable must be shielded when run in the <br /> Caution ; <br /> same conduit as the pump wires. When using shielded <br /> cable,connect the cable shield to earth ground at both <br /> the controller and the contractor's box. <br /> Field-Wiring the CPT Pump with Quick-Set Feature <br /> Step 1: Remove the cover from the capacitor compartment. <br /> Step 2: Pull the pigtail wires into the capacitor compartment. <br /> ARE260-240 Rev.A ♦ 6/97 3-11 Chapter 3: Installation <br />