Laserfiche WebLink
0 <br /> Daljit Sabharwal, Vice President <br /> September 4, 2002 <br /> Page 4 <br /> 12. Remove the crystallized ammonium hydroxide covering the machine. Remove <br /> the build-up on the floor around the ammonium hydroxide etch machine. CFC <br /> 8003.1.3.2 <br /> 13. Repair the damaged piping system that is leaking ammonium hydroxide. CFC <br /> 8001.4. <br /> 14. Label the mislabeled container from sodium hydroxide to ammonium hydroxide. <br /> CFC 8001.7 <br /> 15. Repair the damaged electrical box at the ammonium hydroxide machine. CFC <br /> 8504 <br /> 16. Remove the wood risers and replace with non-combustible risers. Remove the <br /> chemical build-up of ammonium hydroxide on the floor. CFC 8003.1.3.2 <br /> 17. Repair the corroded and damaged electrical wiring on the board cleaning line. <br /> CFC 8504 <br /> 18. Provide floor and trench protection, around the board cleaning line, where the <br /> floor has been severely deteriorated by the acid exposure. CFC 8003.1.3.2 <br /> 19. Repair the pipe system in the board cleaning line that is leaking chemicals. CFC <br /> 8001.4.7 <br /> 20. Repair the piping on the Board Cleaning machine. CFC 8001.4.7 <br /> 21. Remove the build-up of spilled pre-dip chemicals from the Electrolyte process <br /> area. CFC 8001.5 <br /> 22. Repair the ventilation system leaking chemicals back through the joints of the <br /> soldier flux unit. Clean around the soldier flux unit. CFC 8001.4.3 <br /> 23. Repair the soldier flux unit that is using a bucket to capture the overflow. CFC <br /> 8001.4.7.3 <br /> 24. Remove the chemical crystal build up on the table tray for the Metex Soldier <br /> table. CFC 8001.4 <br /> 25. Remove the open container of hazardous waste dated 2000 from the Metex <br /> Soldier table area and store in waste area. CFC 8001.11.9 <br /> 26. Repair the damaged pipe on the quicksilver line. CFC 801.4 <br /> 27. Repair the hydraulic leak on the quicksilver line. CFC 8001.4.7 <br /> 28. Clean up the corrosion on the electrical wiring and chemical spillage around the <br /> quicksilver line. CFC 8504 <br /> 29. Repair the joints with a weld on the ventilation unit pipe. Chemical residue <br /> running down the outside of the pipe is leaking from the joints. CFC 8001.4.7 <br /> 30. Repair all leaks from the Marseco cleaner machine. CFC 8001.4.7 <br /> 31. Remove the duck tape and repair the valve leak on the pumice rinse water <br /> machine. Remove the spill over product. CFC 8001.4 <br /> 32. Repair the leaks from the permanganate unit. The permanganate is leaking from <br /> the piping, damaging the electrical units and is spilling onto the floor from the <br /> unit. Clean up chemical build-up around machine. CFC 8001.4.7, 8504 <br /> 33. Repair the outer layer stripper vent pipe that is leaking. Remove the duct tape on <br /> the piping and weld the pipe at the seams and at the pipe connection. CFC <br /> 8001.4 <br /> 34. Provide a cover plate for the exposed electrical in the tin stripper unit. CFC 0804 <br />