Laserfiche WebLink
cheeSe MelteR <br />10 P/N 1010983 Rev B 05/08 <br />PrograMMing <br />general information <br />cyc (total cycle time) refers to the total amount <br />of cooking time set for the product. <br />rate (shot interval time) is the time set between <br />shots of steam during a complete cycle. <br />sHot (steam shot time) is used to adjust the <br />water volume during each solenoid operation or <br />shot of steam. <br />The amount of steam produced by your unit <br />depends on the amount of water sprayed onto the <br />steam generator. The generator may flood if the <br />RATE setting is too low or if the SHOT setting is <br />too high. <br />To prevent flooding, increase the RATE to allow <br />more time for generator heat recovery and <br />decrease the SHOT to reduce the water volume. <br />Adjustments should be made to both values to <br />determine the best settings for your cooking needs. <br />factory settings <br />The RS-250 is factory programmed for the following <br />default values: <br />Programming the rs-250 <br />note: cyc, rate, and sHot are sequential <br />operation per channel for all programming (you <br />must perform all steps for cyc and rate to <br />change sHot). <br />note: cyc, rate, and sHot are only dis- <br />played momentarily during the programming <br />sequence after pressing the Program button. <br />cyc (total cycle time) <br /> 1. Turn the unit on. Allow the unit to preheat for <br />30 minutes. <br />note: During preheating, the display flashes <br />“loW”. When unit reaches operating tempera- <br />ture, the display shows “rDy1” or “rDy2” and <br />the active channel indicator light is lit. <br />RDY1 <br />cH-1 cH-2 range <br />cyc 21 secs 24 secs 0 sec to <br />99 mins 59 secs <br />rate 7 secs 7 secs 1 sec to <br />5 mins 59 secs <br />sHot 0.21 secs 0.21 secs 0.10 sec to <br />2.50 secs