Laserfiche WebLink
Installation GU ria: AdvanTexrM-ASC Treat rr nt Systems <br /> r <br /> Step 4 <br /> Installing Access Risers on Processing Tank <br /> Step 4A: Orienting Riser <br /> Orient grommets as shown in your system sketch. The riser <br /> that will have the RSV installed in it (inlet riser for Mode <br /> 3; outlet riser for Mode 1) must be installed such that the <br /> RSV inlet piping is oriented to accept the Filtrate Return <br /> Line. For any risers that will have electrical conduits run- <br /> ning to them, try to orient electrical grommets to minimize <br /> the number of bends because the National Electrical Code <br /> limits the sum total of all bends in a run to 360 degrees. <br /> IM" Y Step 413:Applying Adhesive to Adapter <br /> Apply adhesive to the outside surface of the riser tank <br /> adapter. <br /> H <br /> Applying adhesive to riser tank adapter <br /> Step 4C: Placing Riser <br /> Carefully slide the riser onto the adapter. Be sure to orient <br /> the riser correctly before adhesive cures. <br /> 3. <br /> t i. <br /> es, <br /> y Placing access riser onto adapter <br /> t <br /> Step 4D: Sealing Riser-Adapter Joint <br /> Apply adhesive to the inside of the adapter and riser joint. <br /> Use a putty knife or similar tool to form a continuous fillet <br /> between the tank adapter and the inside of the riser. <br /> _ y � <br /> Applying adhesive to riser-adapter joint <br /> c0 2081 Orenco Systems Inc. EIM-ATX-AX-1 <br /> Information subject to change without notice Rev 1.48101 <br />