COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

replace oil (or schedule oil maintenance from ARID Certified Permeator Technician) if oil change is warranted. The maintenance interval for draining and replacing the oil is every 5,000 hours (or once a year). If the oil level is low prior to the oil change interval, the owner/operator can `top up' the oil level (See ARID Permeator AT-150 section of IOM for Procedure). Only ARID Part Number AT-11 oil is authorized for usage in the Permeator AT-150. 1.3. Annual Inspection and Testing to Be Performed By a Certified Technician. The following procedures are recommended to be conducted in the order listed. 1 .3.1. Perform weekly and quarterly inspection prior to Annual Inspection. 1 .3.2. For GDF installations with CAS installed, conduct static pressure performance of the Healy Clean Air Separator (EO VR-201 or VR-202, Exhibit 4). 1 .3.3. Conduct pressure decay test (TP-201.3 and EO VR-201 or VR-202, Exhibit 8). 1 .3.4. For GDF installations with ARID Permeator AT-150 installed, conduct Permeator compliance procedure (EO VR-201 or VR-202, Exhibit 15). 1 .3.5. Conduct dispenser vapor line integrity test (Section B-3 of the Start-up / New Installation /Warranty / Annual Testing Form) found in the Healy dispenser manual for each dispenser at GDF. Repair all leaks. 1 .3.6. Conduct V/L test on all nozzles (EO VR-201 or VR-202, Exhibit 5 or a CARB approved alternate test procedure). Adjust and replace as necessary. 1.4. Procedure for Operator Reconnection of Breakaway and Testing Fueling Point after Drive- Off. Note: The following reconnection procedure does not require a Certified Technician as long as the components pass inspections and tests. If any of the tests fail, requiring removal of the fueling point or dispenser from service, contact a Certified Technician for repairs. Breakaway reconnections and/or service by the GDF owner/operator or a Certified Technician shall be entered into the GDF Maintenance Log. 1 .4.1. Inspection: After a Drive-Off, remove the dispenser from service and inspect the nozzle, hoses and breakaway for damage. If any of the components are damaged, replace them as necessary or contact a certified technician for repair. If the break-away has separated, proceed to the next section. Note: For Healy breakaways only, verify that the tip of the shear screw installed prior to the Drive-Off is removed from the dispenser end body (inlet) of the breakaway. If the tip cannot be removed, the breakaway must be replaced. 1-3 CARB Approved IOM 1 —Systems Scheduled Maintenance—EO's VR-201 and VR-202