Laserfiche WebLink
wowwww"w- <br /> Testing the new spout assembly <br /> IMPORTANT:All spout replacements must be tested to ensure the installation has been <br /> completed correctly. <br /> 1. Dispense product into a container deep enough to cover the small hole near the tip of the <br /> spout and verify that the dispensing rate is between 6.0-10.0 gpm with the nozzle lever <br /> held in the full open (handheld) position. While dispensing, with the nozzle lever held in <br /> the full open (handheld) position, immerse the spout until the hole is covered. If shutoff <br /> does not occur, turn off the dispenser, remove the spout, and check the o-rings. Replace the <br /> 0-rings (part number 6206-OR) as necessary and repeat step 4 of"Installing the new spout <br /> assembly," and then repeat this step. If shutoff does occur, go to the next step. <br /> NOTE: If repeated attempts to repair nozzle does not result in successful shut off, replace the <br /> nozzle. Contact FFS Technical Support for assistance. <br /> 2. Repeat the previous step twice (for a total of three tests) to ensure that the auto shutoff <br /> feature is working properly. There should be no hesitation to the shutoff; it should be quick <br /> and positive. If shutoff tests are successful, the nozzle can be put back into service. If either <br /> additional shutoff test fails, turn off the dispenser, remove the spout, and check the o-rings. <br /> 3. Replace the o-rings as necessary (part number 6206-OR). Repeat step 4 of"Installing the <br /> new spout assembly," and then repeat the previous two steps. <br /> NOTE: If repeated attempts to repair the nozzle does not result in successful shut off, take the <br /> nozzle out of service and replace it. <br /> Replacing the scuffguard <br /> NOTE:The part number needed for the following procedure depends on the scuffguard color. <br /> Contact FFS Technical Support for the correct part number. <br /> 1. Use the instructions in "Removing the mini-boot" to remove the mini-boot. <br /> 2. Slide a long screwdriver under the scuffguard in the area of the main valve cap nut on the <br /> top of the nozzle. (See image reference 5 in "Illustration and replaceable parts.") <br /> 3. Pry upward to clear the top of the main valve cap, and then pull steadily toward the spout <br /> to remove. <br /> 4. Installation is the reverse of this method. It works best with the butt of the nozzle held in a <br /> vise. In cold weather the scuffguard may not be pliable enough to use the above method, <br /> carefully (do not damage the nozzle) cut the old scuffguard off with a knife and replace it <br /> with a new, warmed, scuffguard by using the reverse of the previous step. <br /> S. Use the instructions in "Installing the new mini-boot" to install the mini-boot and test <br /> nozzle operation. <br /> N­ <br /> 6 6 <br /> CARB approved IOM 2-HEAL Y'900 Nozzle Series-Execu ive Orders VR-201 and VR-202 <br />