Laserfiche WebLink
a <br /> Photo K Photo L <br /> ❑ Remove the cover from the capped elbow and install a 1/2" close nipple into one of the <br /> conduit hub openings. To this nipple, add a 1/2" x 3/4" electrical reducing bushing. Install <br /> this completed assembly into the open conduit hub on the junction box installed above, see <br /> photo M. <br /> ❑ Install the female half of the electrical union on to the 1/2" x 4-1/2" electrical nipple, then <br /> install the nipple into the open conduit hub on the capped elbow. <br /> ❑ Thread the motor wires through the male half of the electrical union and install the part into <br /> the motor, see photo O. <br /> ❑ Carefully thread the motor wires up through the 4-1/2" nipple, into the capped elbow. Pull <br /> the wires tightly as the two halves of the union are aligned and screw down the securing <br /> collar. Be sure no wires are pinched between the two halves of the union. <br /> ❑ Push the motor wires through the capped elbow into the junction box and replace the cover <br /> on the capped elbow. <br /> ❑ Leave about 6" of wire on each piece in each bundle of wires, then strip all wires 3/8" and <br /> join, color for color using wire nuts supplied. Replace the cover, see photo N. <br /> { <br /> N <br /> 9 <br /> Photo M Photo N <br /> s <br /> GARB Approved IBM 8-Gilbarco Gasboy 9888 Series-Executive Orders VR-281 and VR-282 <br />