Laserfiche WebLink
t <br /> Photo O Photo P <br /> 10. CONNECTING VAPOR LINES: (See Photos F, G, P, Q & R) <br /> ❑ Apply pipe sealant to the threads on the 1" x 3/4" male threaded nipple and install the 3/4" <br /> end into the product outlet on the dispenser. Note: Gasboy has an alternate 1" discharge <br /> fitting. If so equipped, installer will need to supply their own 1" x 2" nipple to install the <br /> Healy CX6-A splitter fitting. Do both sides if dual hose. <br /> ❑ Install the CX6-A splitter adaptor to the 1" threaded portion of the nipple and tighten both <br /> securely, with the final turn positioning the 1/4" vapor outlet of the CX6-A facing the closest <br /> edge of the cabinet. Do both sides if dual hose, see photo P. <br /> ❑ Note: Use Oil and gasoline compatible PTFE tape on the following steps. <br /> ❑ Assemble a 1/4" close nipple and elbow to the vapor hole in the CX6-A adaptor. Position <br /> the elbow to face downward. Do both sides if dual hose. <br /> ❑ Assemble the 1/4" x 2" nipple into elbow and then attach another elbow, positioned to face <br /> the cabinet wall when tightened. Do both sides if dual hose. <br /> ❑ Install the 1/4" x 3" nipple from inside the cabinet slide the nipple through the cabinet, <br /> toward the elbow but slide on the hole mask washer (white paper towards cabinet) between <br /> the outside of the cabinet and the elbow fitting. Do both sides if dual hose, see photos P & <br /> Q. <br /> ❑ Install the 1/4" coupling to the 1/4" x 3" nipple and then install a 1/4" NPT x 1/2" flare <br /> straight fitting in the coupling — tighten securely. Do both sides if dual hose, see photo Q. <br /> ❑ Remove the white protective tape from the hole mask washer installed above and press <br /> adhesive surface against cabinet. Do Both sides if dual hose. <br /> 10 <br /> GARB Approved IOM 8-Gilbarco Gasboy 9800 Series-Executive Orders VR-201 and VR-202 <br />