Laserfiche WebLink
Photo Q Photo R <br /> `CL FILTEH 7q <br /> ❑ Note- Use Oil and gasoline compatible PTFE tape on the following steps. <br /> ❑ Install the 1/2" street elbow to the inlet of the pump, tighten to face left, see photo R. <br /> ❑ Install the 1/2" NPT x 5" nipple to the elbow above. Install and tighten the 1/2" ball valve <br /> such that when the handle is closed, it points toward the outside of the cabinet. <br /> ❑ To the ball valve, install a 1/2" close nipple and the 1/2" x 1/4" x 1/2" reducing tee. <br /> Completely tighten with the 1/4" opening facing up. <br /> ❑ To the tee, install the 1/4" NPT plug and the 1/2" NPT x 1/2" x 1/2 " flare tee. NOTE: If <br /> upgrade is being done on a single sided dispenser, install the 1/2" flare cap provided, onto <br /> the remaining tee opening. <br /> ❑ Make up a piece of 1/2" OD copper tube that will go from the flare tee on the ball valve to <br /> the straight flare fitting on the coupling leading to the CX6-A fitting outside the cabinet, see <br /> photo F. <br /> ❑ Refer to photo G for the next piece of 1/2" OD tube that is run from the CX6-X fitting on the <br /> other side of the dispenser. Carefully bend the piece to fit between the two meters and line <br /> up with the remaining port on the tee on the motor inlet plumbing. <br /> ❑ The vacuum pump is now well contained by both the electrical and vapor plumbing. If <br /> further fastening is required, drill two 5/16" holes up from below the center panel and <br /> through the mounting plate on the VP1000. Secure the pump with the nuts and bolts <br /> supplied. <br /> 11. WIRING THE ELECTRONICS <br /> ❑ Remove the screws from the two indicator/display panels and allow to lay flat. <br /> ❑ The interface module assembly will be mounted on top of the electronics chassis in the <br /> space at the right rear corner looking from the non `J' box side of the dispenser. Before <br /> mounting, however, the red "DANGER" must be relocated about 5" to the left. Also, it is <br /> easier to make the wire connections with the module lifted up rather than secured to the <br /> chassis, see photo S. <br /> II <br /> CARR Approved IN 8-Gilbarco Gasboy 9800 Series-Executive Orders VR-201 and VR-202 <br />