Laserfiche WebLink
8. WAYNEVACTmREMOVAL: <br /> ❑ Disconnect and lockout the power to the dispenser. <br /> ❑ Open the dispenser cabinet doors and observe vapor plumbing. <br /> ❑ Close the vapor recovery (Stage II vapor return line) impact valve. If there is no impact <br /> valve, be sure to have proper plugs or caps available to plug the Stage II line before <br /> disconnecting the WayneVACTM equipment. <br /> ❑ On the 'B' side (side opposite IGEM board #173976, see photo H), of the dispenser locate <br /> the WayneVACTM electronics control board #887227 photo I, and disconnect cables going <br /> to the WayneVacTM motors (4 connectors, 2 signal and 2 thermister). Also, remove 2 green <br /> ground wires going to the chassis. <br /> L-I a <br /> X11 84 { <br /> Oil <br /> ti <br /> {t y <br /> r 5 f <br /> L■ � I <br /> i % P <br /> Photo H Photo I <br /> ❑ On each motor, open the electrical union attached to the electronic housing, remove the <br /> covers, disconnect the cables, and ground wire inside. <br /> ❑ On each motor, follow the electronic wire conduit to where it penetrates the vapor barrier on <br /> the floor of the electronics compartment. <br /> ❑ On that conduit, back the lock nut off as far as it will go and then the coupling above the <br /> nut until the thread of the mating part, which is potted and comes from the electronic <br /> compartment through the barrier, is disengaged, see photo J. <br /> 8-8 <br /> CARE Approved IOM 8-Wayne Ovation Series-Executive Orders VR-201 and VR-202 <br />