Laserfiche WebLink
Performing a Cold Boot Installing the ECPU Board <br /> The console begins the restoring process of copying the system setup data you archived in the E2 chip into <br /> the new ECPU board's RAM. Depending on how complicated your system setup data is, this procedure could <br /> last for several minutes. When the restoring process is complete the printer prints out: <br /> ARCHIVE UTILITY <br /> RESTORE SETUP DATA <br /> END TIME: <br /> MMM DD, YYYY HH:MM XM <br /> SYSTEM SETUP <br /> MMM DD, YYYY HH:MM XM <br /> This information is followed by a complete printout of the system setup.The front panel display should read: <br /> MMM DD,YYYY HH:MM:SS XM <br /> BATTERY IS OFF <br /> 7. Press the ALARM/TEST key to acknowledge the alarm.The printer prints: <br /> MMM DD,YYYY HH:MM XM <br /> SYSTEM STATUS REPORT <br /> ALL FUNCTIONS NORMAL <br /> And the front panel display reads: <br /> MMM DD,YYYY HH:MM:SS XM <br /> ALL FUNCTIONS NORMAL <br /> 8. Close and secure the left front door. <br /> 9. If necessary, refer to your System Setup manual to make any corrections or additions to your system setup. It <br /> is good practice to archive your system setup to the E2 chip after you have made any additions or corrections <br /> to the setup. <br /> 13 <br />