Laserfiche WebLink
Replacing Software/Memory ModulesBoard <br /> 1. Perform the "Archiving the System Setup" on page 4. <br /> 2. Switch Off power to the console. <br /> 3. Open the front door of the console and locate the ECPU board Figure 1 on page 6. Figure 8 shows the layout <br /> of software module and the two memory modules (NVMEM-201 and NVMEM-203). <br /> Software Module(Front side) <br /> r, <br /> 0 o v <br /> 0 ® o <br /> Mounting notch(seats over ridge Mounting notch(seats over ridge in <br /> in base of connector-typ all boards) edge of connector)-typ all boards) <br /> U5 U8 U10 U12 <br /> NVMEM-201 Card (Front side) o U3 <br /> P/N 332966-201 ° L 0 0 <br /> (NON-ISD) <br /> L <br /> 0 0 0 <br /> D O <br /> U5 U8 U10 U12 <br /> O U3 <br /> El j° a a a o <br /> NVMEM-203 Card(Front side) <br /> P/N 332966-203 <br /> (ISD) <br /> 0 0 0 <br /> C) O � Do <br /> 637-1.ops <br /> Figure& Software and Memory Module Component Layouts <br /> 4. Follow the instructions in Figure 9 to install or replace these modules. <br /> 14 <br />