Laserfiche WebLink
Replacing Software/Memory Modules on the ECPU Board Installing the ECPU Board <br /> Removing modules <br /> 2 Q 8 i o 3 Use your fingers to spread <br /> retaining clips away from <br /> Attach one end of the <br /> antistatic wrist strap to _� � _ the module board edges, <br /> your wrist and the other � + Fill <br /> tilt in the board to the front <br /> _ F-1 of the console and lift it out. <br /> end to the bare metal <br /> base inside the console. Module retaining clips <br /> (one on each end) <br /> ensole OFF. <br /> urn <br /> Removing Software and Memory Modules <br /> Seat module in connector J1 at <br /> r <br /> an angle with component side facing --4 <br /> the front of the console. Make i it <br /> sure that notch in the bottom of <br /> the board is over ridge in base of <br /> connector,then push board back <br /> until retaining clips snap around the <br /> board's edges.DON'T FORCE BOARD <br /> or you may damage socket! Check <br /> that notch and ridge are aligned h\1 <br /> correctly then try again. t: ' ECPU board <br /> Retaining clip(2) ---------- <br /> Front of console <br /> Jl J2 — 7 <br /> View A-A(above) <br /> Installing Software and Memory Modules <br /> Figure 9. Removing and Installing a Software or Memory Module <br /> 5. Perform a cold boot as described in "Performing a Cold Boot"on page 12. <br /> 15 <br />