Laserfiche WebLink
Replacing the TLS Setup Storage <br /> This procedure assumes you are changing the TLS Setup Storage Device, but not the ECPU board. <br /> 1. Switch Off power to the console. Open the left front door of the console and locate the ECPU board <br /> [reference Figure 1 on page 61. <br /> 2. Remove the ECPU board following the instructions in "Replacing the ECPU Board" on page 6 with one <br /> Q exception - DO NOT turn the Battery Backup switch OFF as instructed in that procedure. <br /> 3. Locate the TLS Setup Storage device on your ECPU board (see Figure 2 on page 7 or Figure 3 on page 8) as <br /> appropriate. <br /> 4. Remove the TLS Setup Storage device following the instructions shown in Figure 4 on page 9 or Figure 6 on <br /> page 10 as appropriate. <br /> 5. Replace the TLS Setup Storage device following the instructions shown in Figure 5 on page 9. <br /> Q 6. Replace the ECPU board following the instructions shown in Figure 7 on page 11 with one exception - you <br /> can ignore step 4 in Figure 7 since you did not turn off battery backup when you removed the board. <br /> 7. Close the left front door of the console and restore AC power to the console. <br /> The display will cycle through the following warm boot screens: <br /> SYSTEM WARM START <br /> SYSTEM SELF TEST <br /> SYSTEM STARTUP COMPLETE <br /> At this point front panel display reads: <br /> MMM DD,YYYY HH:MM:SS XM <br /> ALL FUNCTIONS NORMAL <br /> 8. You should archive the current system setup data in the blank TLS Setup Storage device following instructions <br /> in "Archiving the System Setup" on page 4. <br /> 16 <br />