|
REVISIONS
<br /> TENTATIVE IMPROVEMENT PLANS FOR: NO. DATE: DESCRIPTION
<br /> 115/13/21 LFD- 1 ST REVIEW
<br /> 05/18/2 LBID- 1ST REVIEW
<br /> SMA CAK S BAK RY STOR 5/18/21 LBID- 1ST REV. SHT#12
<br /> 05118/21 LBID- I S=V-SHI h
<br /> 15040 S. HARLAN ROAD, CITY OF LATHROP, STATE OF CALIFORNIA, 95330 0
<br /> WITHIN PARCEL=APN: 196- 11-020
<br /> Zf
<br /> A05/13/21 LFD- 1 ST REVIEW I f
<br /> TENTATIVE IMPROVEMENTS L 2019 CALIFORNIA PLUMBING CODE 01
<br /> EXISTING 3" SCH 301.0 GENERAL NOTES
<br /> PROPOSED TENANTS "SMALLCAKES" BAKERY STORE, NEW 12"X12"FLOOR DRAIN 40 PVC SANITARY 301.1 APPLICABILITY
<br /> OF THIS EXISTING VACANT COMMERCIAL SPACE,WILL HAVE A CUSTOMER (SEE SHEET S4.0 FOR DETAIL) DRAIN PIPE THIS CHAPTER SHALL GOVERN THE GENERAL REQUIREMENTS,NOT Q R
<br /> SERVING COUNTER,A BAKERY STATION,AN ENCLOSED KITCHEN CLEANING Ir SPECIFIC TO OTHER CHAPTERS,FOR THE INSTALLATION OF PLUMBING 3
<br /> AREA AND A UNISEX ALL-GENDER BATHROOM. THE PREVIOUS BUILT SPACE ° r - - - - SYSTEMS. "
<br /> HAS NO IMPROVEMENTS FROM THE PREVIOUS OCCUPANTS (APNA PUNJAB). I �]
<br /> EXISTING SCH 40 PVC 3X3X3 TEE
<br /> 301.2 MINIMUM STANDARDS c I
<br /> CLIENT WILL PROVIDE SAN JOAQUIN COUNTY ENVIRONMENTAL HEALTH SANITARY CONNECTION WITH UA `�
<br /> PIPE,PIPE FITTINGS,TRAPS,FIXTURES,MATERIAL,AND DEVICES USED IN A
<br /> I 3"CAP AT END PLUMBING SYSTEM SHALL BE LISTED OR LABELED THIRD-PARTY
<br /> EPARTMENT A PLAN REVIEW APPROVAL LETTER. (
<br /> 05/18/21 LAID- 1ST COMMENT I I ,+
<br /> CERTIFIED)BY A LISTING AGENCY(ACCREDITED CONFORMITYM
<br /> THIS SITE HAS A FRONTAGE ROAD(HARLAN RD)ON THE NORTH SIDE OF THEU L - - _ _ _ _ EXISTING HAND ASSESSMENT BODY)AND SHALL COMPLY WITH THE APPROVED ' ''
<br /> PROPERTY. EXISTING 3" SCH WASH SINK APPLICABLE RECOGNIZED STANDARDS REFERENCED IN THIS CODE,AND ,
<br /> 40 PVC SANITARY \ / SHALL BE FREE FROM DEFECTS.
<br /> THE CITY OF LATHROP STORM ACCESS IS NORTH OF THE PROPERTY,WEST OF DRAIN PIPE Q 05/18/21 LBID- 1ST REV. SHT#16 THE INTERSTATE 5 ON-RAMP. EXISTING SCH 40 PVC O BEST IDEAL AREA FOR 301.2.1 MARKING
<br /> 3X3X3 TEE SANITARY EACH LENGTH OF PIPE AND EACH PIPE FITTING TRAP FIXTURE MATERIAL
<br /> CONNECTS TO / 32"X 22"X 21.5" GREASE TRAP REMOVE PIECES OF OLD MOP � b
<br /> CONNECTION AND DEVICE USED IN A PLUMBING SYSTEM SHALL HAVE CAST, STAMPED,
<br /> THE CITY OF LATHROP SEWER ACCESS ON HARLAN RD. EXISTING SANITARY FLOOR SINK&PREPARE AREA
<br /> (SEE SHEET SP1.0 FOR DETAIL) OR INDELIBLY MARKED ON IT THE MANUFACTURER'S MARK OR NAME °p 0 G
<br /> SERVICES (TYP) (SEE G.C.NOTE BELOW FOR FOR PROPOSED MOP FLOOR SINK �, o
<br /> THE CAL WATER IS AT HARLAN RD. 3"VENT TO ROOF \ / INFORMATION) WHICH SHALL READILY IDENTIFY THE MANUFACTURER TO THE END USER Q p c p U
<br /> FROM 3X3X2 TEE OF THE PRODUCT. ° V •. ?° ,A
<br /> THE PG&E GAS UTILITY IS AT HARLAN RD. ` oa 5 n
<br /> 10
<br /> 301.2.3 PLASTIC PIPE,PLASTIC PIPE FITTINGS,AND COMPONENTS �� -� �' '� �` o
<br /> YOU MUST CALL CITY OF LATHROP CAL WATER AND PG&E FOR EXISTING AIR VENT FOR \ PLASTIC PIPE,PLASTIC PIPE FITTINGS,AND COMPONENTS OTHER THAN n i p .x H
<br /> PROPOSED TIE-INS/STUB-UPS TO THESE BUILT UTILITIES. NEW FLOW REDUCER THOSE FOR GAS SHALL COMPLY WITH NSF 14. `'' S �" U ¢ w rn Cn
<br /> \ PROPOSED 3-COMPARTMENT SINK P4UTILITY NOTES: CHAPTER 4 PLUMBING FIXTURES AND FIXTURE FITTINGS � ��
<br /> EXISTING AIR VENT FOR O 402.9 DESIGN AND INSTALLATION OF PLUMBING FIXTURES.
<br /> THE UNDERGROUND UTILITIES SHOWN HAVE BEEN LOCATED FROM FIELD SURVEY Q3 05/18/21 LBID- 1 ST REV. SHT#12 PLUMBING FIXTURES SHALL BE INSTALLED SUCH THAT FIXTURE FITTINGS Z
<br /> INFORMATION AND EXISTING DRAWINGS.THE SURVEYOR MAKES NO GUARANTEE GREASE TRAP
<br /> SHALL BE IN ACCORDANCE WITH THE BACKFLOW PREVENTION �..,
<br /> THAT THE UNDERGROUND UTILITIES SHOWN COMPRISE ALL SUCH UTILITIES IN THE EXISTING AIR VENT CONNECTIONS REQUIREMENTS OF ASME Al 1 2 . 1 8 . 1 /CSA B 1 25 . 1 . Z
<br /> AREA,EITHER IN SERVICE OR ABANDONED.THE SURVEYOR FURTHER DOES NOT (SEE CHAPTER 8-INDIRECT WASTES) Z
<br /> GUARANTEE THAT THE UNDERGROUND UTILITIES SHOWN ARE IN THE EXACT
<br /> LOCATION INDICATED ALTHOUGH HE DOES CERTIFY THAT THEY ARE LOCATED AS (SEE G .NOTE BELOW FOR INFORMATION) 403.0 ACCESSIBLE PLUMBING FACILITIES
<br /> ACCURATELY AS POSSIBLE FROM INFORMATION AVAILABLE.THE SURVEYOR HAS 403.1 GENERAL. �. a
<br /> NOT PHYSICALLY LOCATED THE UNDERGROUND UTILITIES. WHERE ACCESSIBLE FACILITIES ARE REQUIRED IN APPLICABLE BUILDING C)
<br /> REGULATIONS,THE FACILITIES SHALL BE INSTALLED IN ACCORDANCE o
<br /> BUILDING CODE ANALYSIS: Q3 05/18/21 LBID- 1ST REV. SHT#12 WITH THOSE REGULATIONS.407.3 LIMITATION OF HOT WATER
<br /> TEMPERATURE FOR PUBLIC LAVATORIES.HOT WATER DELIVERED FROM o
<br /> A05/18/21 LBID PUBLIC-USE LAVATORIES SHALL BE LIMITED TO A MAXIMUM N
<br /> OCCUPANCY GROUP: GROUP B-1 (CBC 304.1) 2ND COMMENT TEMPERATURE OF 120°F 49°C BY A DEVICE THAT IS IN ACCORDANCE
<br /> TYPE OF CONSTRUCTION: SB EXISTING) BEST PLACE FOR OVERSIZED GREASE TRAP RECOMMENDED BY CITY WITH ASSE 1070 OR CSA B 125 3. THE WATER HEATER THERMOSTAT SHALL ~
<br /> FIRE SPRINKLERS: YES 05/18/21 LBID 3RD COMMEN PROPOSED PLUMBING PLAN y
<br /> - 1'-0" OF LATHROP. CONTRACTOR TO USE BEST CONSTRUCTION&INSTALLATION NOT BE CONSIDERED A CONTROL FOR MEETING THIS PROVISION.
<br /> STORIES: 1 SCALE: 3/4" e N
<br /> BUILDING HEIGHT: 10'-0" JUGEMENT TO ATTACH 3-COMPARTMENT SINK TO INDIRECT AIR VENT AND
<br /> ALLOWABLE FLOOR AREA: 1,920ftz TO PROPOSED 12" FLOOR DRAIN. 411.0 WATER CLOSETS 0 Oo
<br /> 3 v, .
<br /> FLOOR AREA: 1,920ftz 411.1 APPLICATION.
<br /> WATER CLOSETS SHALL COMPLY WITH ASME Al 12.19.2/CSA B45.1,ASME Al
<br /> A05/18/21 LBID 4TH COMMENT 12.19.3/CSA B45.4,OR CSA B45.5/IAPMO Z124. WATER CLOSET BOWLS FOR
<br /> OCCUPANCY LOAD PER(CBC 1004-TABLE 1004.5) PERSONS PUBLIC USE SHALL BE OF THE ELONGATED TYPE. TT��
<br /> ACCESSORY STORAGE AREAS 1 O Q
<br /> 417.0 FAUCETS AND FIXTURE FITTINGS w
<br /> ASSEMBLY WITHOUT FIXED SEATS (STANDING SPACES) 42 417.1 APPLICATION.
<br /> BUSINESS AREAS 6 FAUCETS AND FIXTURE FITTINGS SHALL COMPLY WITH ASME Al 12.18. 1 Q O Q
<br /> KITCHEN,COMMERCIAL 3 /CSA B 125.1. FIXTURE FITTINGS COVERED UNDER THE SCOPE OF NSF 61
<br /> TOTAL OCCUPANCY LOAD 52 SHALL BE IN ACCORDANCE WITH THE REQUIREMENTS OF NSF 61. Z scq
<br /> 05/18/21 LBID 4TH COMMENT 420.0 SINKS
<br /> 19 CALIFORNIA BUILDING CODE 420.1 APPLICATION.
<br /> W o
<br /> SINKS SHALL COMPLY WITH ASME Al 1 2. 1 9. 1/CSA B45 .2,ASME Al 12. 1
<br /> 9.2/CSA B45 . 1 ASME A112.19.3/CSA B45.4, OR CSAB45.5/IAPMO Z124. U
<br /> CHAPTER 10-MEANS OF EGRESS MOVEABLE SINK SYSTEMS SHALL COMPLY WITH ASME Al 12. 19. 12. Z
<br /> SECTION 1004-OCCUPANT LOAD W
<br /> 420.2 WATER CONSUMPTION.
<br /> 1004.1 DESIGN OCCUPANT LOAD. IN DETERMINING MEANS OF EGRESS O
<br /> REQUIREMENTS, THE NUMBER OF OCCUPANTS FOR WHOM MEANS OF EGRESS SINK FAUCETS SHALL HAVE A MAXIMUM FLOW RATE OF NOT MORE THAN
<br /> FACILITIES ARE PROVIDED SHALL BE DETERMINED IN ACCORDANCE WITH 2.2 GPM AT 60 PSI(8.3 L/M AT 4 14 KPA)IN ACCORDANCE WITH ASME `- H
<br /> THIS SECTION AND TABLE 1004.5
<br /> (MAXIMUM FLOOR AREA ALLOWANCES PER OCCUPANT). 05 LBID- 1ST REV. SHT#12
<br /> CHAPTER
<br /> 8 INDIRECT WASTES
<br /> 801.3 FOOD AND BEVERAGE HANDLING ESTABLISHMENTS.
<br /> ESTABLISHMENTS ENGAGED IN THE STORAGE,PREPARATION, SELLING,
<br /> SERVING,PROCESSING,OR OTHER HANDLING OF FOOD AND BEVERAGE
<br /> INVOLVING THE FOLLOWING EQUIPMENT THAT REQUIRES DRAINAGE
<br /> SHALL PROVIDE INDIRECT WASTE PIPING FOR REFRIGERATORS,
<br /> REFRIGERATION COILS,FREEZERS,WALK-IN COOLERS,ICEBOXES,
<br /> ICEMAKING MACHINES, STEAM TABLES,EGG BOILERS,COFFEE URNS ANDCA �•T�
<br /> HOT-AND-COLD DRINK DISPENSERS,AND SIMILAR EQUIPMENT. N OBREWERS,
<br /> Q A W I-I
<br /> � woo
<br /> UNAUTHORIZED CHANGES&USES:
<br /> The design firm preparing these plans will not be responsible for,or liable for,
<br /> unauthorized changes to or uses of these plans.All changes to these plans MUST be in
<br /> PERMIT NOTE: writing and must be approved by the preparer of these plans.
<br /> The issuance of a permit or approval of plans or specifications shall not be deemed or CHECKED BY: J.AGUIRRE (E.O.R.)
<br /> construed to be a permit for an approval of any violation of any of the provisions of the G.MENDOZA
<br /> California state building codes or local ordinances. CONSTRUCTION CONTRACTOR NOTE: DESIGNED BY: PHANTOM DESIGNS
<br /> Construction contractor agrees that in accordance with generally acepted construction G.MENDOZA
<br /> practices,construction contractor will be required to assume sole and complete DRAWN BY: PHANTOM DESIGNS
<br /> Responsibility for job site conditions during the course of constructionof the project, SCALE: SCALE: 1/4"= F-0"
<br /> DESIGN NOTE: including safety of all persons and property;that this requirement shall be made to apply
<br /> Electronic versions of the line work on this plan may not be consistent with other continuously and not to be limited to normal working hours, and construction contractor DATE: 04/30/2021
<br /> dimensions,notes,details,or descriptions which control the intent design. electronic 41 0 21 41 further agrees to defend,imdemnify and hold design professional harmless from any
<br /> versions of the plan are not to be used to establish the location of property or and all liability,real or alleged,in connection with the performance of work on this
<br /> improvements in the field. project, except liability arising from the sole negligence of the design professional.
<br /> SCALE: 1/4"= 1'-0" P 1 0
<br />
|