Laserfiche WebLink
SYMBOLS DESCRIPTION <br />FLUORESCENT FIXTURE, WITH FIXTURE <br />DESIGNATED BY LETTER. <br />NIGHT LIGHT - NOT SWITCHED <br />CEILING OR WALL MOUNTED FIXTURE <br />JUNCTION BOX <br />SINGLE/DOUBLE FACED EXIT SIGN - NOT <br />SWITCHED <br />DOUBLE HEAD EMERGENCY LIGHT WITH BATTERY <br />BACK UP. <br />SINGLE POLE SWITCH, +48" A.F.F. <br />DIMMER SWITCH <br />OCCUPANCY SENSOR SWITCH <br />THERMAL OVERLOAD SWITCH <br />DUPLEX RECEPTACLE, +18" A.F.F. <br />250 VOLT RECEPTACLE PER UNIT <br />REQUIREMENTS <br />HALF SWITCHED DUPLEX RECEPTACLE <br />POWER/PHONE/DATA FLUSH FLOOR OUTLET <br />TELEPHONE/DATA SYSTEM OUTLET, 4" SQUARE <br />BOX AND COVERPLATE, 3/4"C. TO CEILING <br />SPACE UNLESS SHOWN WITH HOMERUN, +18" <br />A.F.F. <br />FOURPLEX RECEPTACLE, +18" A.F.F. <br />DUPLEX RECEPTACLE ABOVE COUNTER, VERIFY <br />HEIGHT <br />*** ALL SYMBOLS ON LEGEND MAY NOT APPLY TO DRAWING(S). *** <br />OUTLET CONTROL INDICATOR <br />THREE WAY SWITCH, +48" A.F.F. <br />TELEVISION OUTLET PLASTER RING AT +18" <br />A.F.F. (U.N.O.) HUBBELL COVERPLATE. 3/4"C. <br />TO CEILING SPACE UNLESS SHOWN WITH <br />HOMERUNS. <br />CONDUIT BELOW FLOOR OR UNDERGROUND <br />CONDUIT IN WALL OR ABOVE CEILING <br />HOMERUN TO PANEL (SEE GROUNDING NOTE) <br />MOTOR CONNECTION <br />DISCONNECT SWITCH <br />DUCT SMOKE DETECTOR <br />E EXISTING LIGHT OR DEVICE TO REMAIN <br />ER <br />EXISTING LIGHT OR DEVICE TO BE <br />REMOVED OR RELOCATED <br />R RELOCATED LIGHT OR DEVICE <br />N NEW LIGHT OR DEVICE <br />A.F.F.ABOVE FINISHED FLOOR <br />C CONDUIT <br />E.C.EMPTY CONDUIT WITH PULLWIRE <br />E.D.F.ELECTRICAL DRINKING FOUNTAIN. <br />GND GROUND <br />MLO MAIN LUGS ONLY <br />MCB MAIN CIRCUIT BREAKER <br />S.E.S.SERVICE ENTRANCE SECTION <br />WP WEATHER PROOF <br />WR WATER RESISTANT <br />U.N.O.UNLESS NOTED OTHERWISE <br />SECURITY CAMERA <br />A.PRIOR TO SUBMITTING BID, CONTRACTOR SHALL EXAMINE ALL GENERAL <br />CONSTRUCTION DRAWINGS AND VISIT THE CONSTRUCTION SITE TO BECOME <br />FAMILIAR WITH EXISTING CONDITIONS UNDER WHICH HE WILL HAVE TO <br />OPERATE AND WHICH IN ANY WAY AFFECTS THE WORK UNDER HIS CONTRACT. <br />NO SUBSEQUENT ALLOWANCE WILL BE MADE IN BEHALF OF THE CONTRACTOR <br />FOR ANY ERROR OR NEGLIGENCE ON HIS PART. <br />B.THE CONTRACTOR SHALL BE HELD FULLY RESPONSIBLE FOR THE PROPER <br />RESTORATION OF ALL EXISTING SURFACES REQUIRING PATCHING, <br />PLASTERING, PAINTING AND /OR OTHER REPAIR DUE TO THE INSTALLATION OF <br />ELECTRICAL WORK UNDER THE TERMS OF THE CONTRACT. CLOSE ALL <br />OPENINGS, REPAIR ALL SURFACES, ETC., AS REQUIRED. <br />C.SEE ARCHITECTURAL DRAWINGS FOR ALL DIMENSIONS, ELEVATIONS AND <br />BUILDING DETAILS. VERIFY LOCATION OF ALL OUTLETS, SWITCHES, AND WALL <br />MOUNTED LIGHTING FIXTURES WITH ARCHITECTURAL DRAWINGS AND ACTUAL <br />CONDITIONS. SEE ARCHITECTURAL REFLECTED CEILING PLAN FOR EXACT <br />LOCATION OF LIGHTING FIXTURES. VERIFY ALL CEILING TYPES WITH <br />ARCHITECTURAL DRAWINGS BEFORE ORDERING FIXTURES. <br />D.PRIOR TO ROUGH-IN AND FINAL CONNECTION, VERIFY ELECTRICAL <br />CHARACTERISTICS AND EXACT LOCATION OF EQUIPMENT. <br />E.GROUT AND SEAL ALL CONDUIT PENETRATIONS OF WALLS AND FLOOR SLABS <br />TO PRESERVE FIRE RATING AND WATERTIGHT INTEGRITY. <br />F.ALL WIRING TO BE INSTALLED IN RACEWAYS. TYPE OF RACEWAY SHALL BE AS <br />REQUIRED BY CODE. MINIMUM CONDUIT SIZE SHALL BE 1/2". MC CABLE WILL <br />BE ALLOWED WHERE APPROVED BY LOCAL AUTHORITIES AND BUILDING <br />OWNER. RACEWAYS RUN ACROSS ROOF SHALL BE MINIMUM 4" ABOVE ROOF. <br />G.BRANCH CIRCUIT WIRING SHALL BE THHN/THWN INSULATION. EXTERIOR <br />WIRING SHALL BE THWN-2. PANEL FEEDERS. SHALL BE TYPE XHHW. ALL WIRE <br />SHALL BE COPPER. MINIMUM WIRE SIZE SHALL BE #12. PER 2011 CEC <br />SEPARATE NEUTRALS ARE TO BE PROVIDED FOR EACH CIRCUIT OR PROVIDE <br />MULTI-POLE HANDLE TIE FOR EACH MULTI-WIRE CIRCUIT <br />H.PROVIDE CODE SIZED BOND WIRE IN ALL CONDUITS. <br />I.ALL ELECTRICAL EQUIPMENT SHALL BE NEW, U.L. APPROVED AND <br />COMMERCIAL GRADE. <br />J.ALL ELECTRICAL WORK SHALL BE INSTALLED IN ACCORDANCE WITH THE <br />LATEST CALIFORNIA ELECTRICAL CODE, (C.E.C.), AND ALL APPLICABLE <br />FEDERAL, STATE AND LOCAL CODES. <br />K.IT SHALL BE THE ELECTRICAL CONTRACTOR'S RESPONSIBILITY TO PROVIDE <br />ONE (1) SET OF COMPLETE CONSTRUCTION DRAWINGS. <br />L.PROVIDE NEW PANEL DIRECTORIES INDICATING SPECIFIC CIRCUIT <br />INFORMATION TO DISTINGUISH EACH CIRCUIT FROM ANY OTHER PER NEC. <br />M.ELECTRICAL CONTRACTOR IS RESPONSIBLE FOR ALL DEMOLITION OF <br />DEVICES, WIRE & CONDUIT. WHERE THESE ITEMS ARE NO LONGER USED ALL <br />UNUSED WIRE SHALL BE REMOVED BACK TO THE PANEL. ANY DOWNSTREAM <br />EQUIPMENT TO REMAIN IN USE SHALL BE RECONNECTED. <br />ELECTRICAL SPECIFICATION <br />1 ELECTRICAL LIGHTING PLAN <br />ELECTRICAL SYMBOLS LEGEND <br />ABBREVIATIONS <br />SHEET TITLE <br />SHEET NO. <br />SUBMITTAL <br />O.T.B.: <br />DATES <br />REVISIONS: <br />DATE#REVISION BY <br />www.stantec.comTEL. 1383 North McDowell Blvd. Suite 250Petaluma, CA 94954707.765.1660Architecture Inc.R <br />ENGINEERING, INC <br />OBISON <br />19401 40TH AVE W., SUITE 302 <br />LYNNWOOD, WA 98036 <br />206-364-3343 tel <br />CONTACT: MARK MANGLICMOT <br />5/14/21 <br />E0.0 <br />OWNER: 21.03.19 <br />BUILDING DEPT: <br />CAD SAVED NAME: <br />PROJECT NO. <br />DRAWN BY: <br />CHECKED BY: <br />2007730004 <br />ELECTRICAL <br />SPECIFICATIONS