Laserfiche WebLink
4.0 SITE CONTROL MEASURES <br /> This section outlines Site control measures to be implemented to minimize potential exposure to <br /> and accidental spread of hazardous substances if encountered during drilling operations. Listed <br /> below are the work zones that shall be established when contaminated material is encountered at <br /> the Site. The zone boundaries may be modified as necessary as new information becomes <br /> available. Changes to the exclusion zone will be communicated daily, during the Site safety <br /> meeting. <br /> 4.1 Exclusion Zone (EZ) <br /> This zone is where there will be direct contact with the potentially contaminated hydrocarbon <br /> impacted soil. The level of PPE required shall be based on the specific hazard, and Site conditions. <br /> The boundary of the Exclusion Zone may be delineated with delineators,caution tape and signage. <br /> Modification to the size and boundary of the exclusion zone will be made in the field based on the <br /> scope of work and the Project Foreman's discretion. <br /> 4.2 Support Zone <br /> This area shall be used as a storage area for operations equipment. <br /> 4.3 Personal Hygiene and General Safety Requirements <br /> Personnel performing or supervising work within the Exclusion Zone, who may be subject to <br /> exposure to vapors,liquids,or contaminated soil, shall observe and strictly adhere to the provisions <br /> of this HASP. Any FREY employee, subcontractor or authorized visitor found disregarding the <br /> provisions of this HASP will be barred from the Site. <br /> No facial hair, which interferes with the effectiveness of a respirator, shall be permitted on <br /> personnel required or potentially required to wear respirators. Personal Protective Equipment <br /> (PPE) must be utilized by on - Site personnel when deemed necessary. Each individual will be <br /> responsible for the proper inspection of his or her PPE prior to entering the exclusion zone. Hard <br /> hats and safety glasses with side shields will be worn on-Site at all times. Personnel that are unable <br /> to pass a fit test as a result of facial hair or facial configuration shall not enter a work area where <br /> respiratory protection may be required. <br /> No open flames or smoking will be permitted in the Exclusion Zone unless a Hot Work Permit has <br /> been initiated. <br /> FREY Page 8 <br />