WORK PLANS - Laserfiche WebLink

Home Browse Search

5.0 TOOLS, EQUIPMENT AND VEHICLES It is the policy of FREY to use tools, equipment and vehicles, that are in a condition that does not pose a hazard to the employee or the environment. This sections outlines basic condition and controls for all tools and equipment utilized. Listed below are the required conditions and inspection guidelines. 5.1 Condition of Tools, Equipment and Vehicles All electric, air, hand tools, equipment and vehicles are to be maintained at a level consistent with the hazards to be encountered on the job Site.All tools and equipment will have appropriate guards and safeties. Hand tools are not to be repaired utilizing tape, wire, glue or any other method to compensate for a proper repair. If there is any doubt, replace the tool. Air compressor hoses will be safety wired. Electrical cords, guards, and safeties will be in proper working order or the tool/ equipment will not be used. 5.2 Inspection Reports Inspection of all tools / equipment and vehicles will be performed on a regular basis. A tool / equipment check list form is to be completed daily, by the Project Foreman, prior to starting any work. 6.0 PERSONAL PROTECTIVE EQUIPMENT This section provides an outline of the personnel protective equipment (PPE) and guidelines that will be implemented to minimize chemical, and physical exposures and accidents during activities at the Site. Where engineering controls and job hazard analyses do not eliminate all job hazards, employees will(where appropriate)wear PPE. These include items such as,hard hats,safety glasses/goggles,hearing protection,foot guards,gloves etc. The project manager under the direction of the FREY Health and Safety Manager will ensure that equipment selected will meet the following requirements: • It will be appropriate for the particular hazard. • It will be maintained in good condition. • It will be properly stored when not in use,to prevent damage or loss. • It will be kept clean, fully functional and sanitary. Protective clothing and PPE can present additional safety hazards. Supervisors will ensure workers wear appropriate clothing and PPE. These items will be worn so as not to create additional hazards. All PPE will be selected in accordance with 29 CFR 1910.132. FREY will provide proper PPE to all employees. All protective clothing will be properly used, stored, selected, and maintained. FREY Page 9